Important Safety Instruction; An Important Notice; Storage Instruction - INFOSEC UPS SYSTEM E6 LCD 1000 RT Manuel Utilisateur

Important Safety Instruction

1.
1.1.

An Important Notice

SAVE THESE INSTRUCTIONS - This Manual Contains Important Instructions that should
be followed during Installation and Maintenance of the UPS
 Do not open the case, as there are no serviceable parts inside. Your Warranty will
be void.
 Do not install the UPS in an environment with sparks, smoke or gas.
 This UPS is equipped with an EMI filter. To prevent potential leakage current
hazard, ensure that the AC main supply is securely grounded.
 This UPS is designed to be installed and commissioned in a sheltered, controlled
environment as follows:
o Operating temperature 0-40°C and 30-90% non-condensing humidity.
o Always avoid contact with direct sunlight.
o Installing the UPS in inflammable or hazardous environment.
o Dusty, corrosive and salty environments can do damage to any UPS.
o Install the UPS indoors as it is not designed for installation outdoors.
 To prevent any overheating of the UPS, keep all ventilation openings free from
obstruction, and do not place anything on top of the UPS. Keep the UPS rear panel
20 cm away from the wall or other obstructions.
 The battery will discharge naturally if the system is unused for any length of time.
 Install the UPS away from objects that give off excessive heat and areas that are
excessively wet.
 Always switch off the UPS and disconnect the batteries when relocating the UPS.
 It should be recharged every 2-3 months if unused. If this is not done, then the
warranty will be null and void. When installed and being used.
 Please ensure that the input voltage of the UPS matches the utility supply voltage.
Use a certified input power cable with the correct plugs and sockets for the
appropriate voltage system.
1.2.

Storage Instruction

For extended storage in moderate climate, the batteries should be charged for 12 hours
every 3 months interval by connecting the UPS to the utility supply and switch on input
breaker located at UPS rear panel. Repeat this procedure every 2 months if the storage
ambient temperature is above 30C.
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 06 11 AA 68 203 03
30