Error Codes - IKA KS 130 basic Mode D'emploi

place evenly on the agitation table, and that all vessels are secu-
rely fastened in place.
AS 130.1 Universal attachment
g
2000
1750
1500
1250
1000
750
500
250
0
0 80
AS 130.4 Reactant glass adapter
g
2500
2000
1500
1000
500
0
0 80

Error codes

Basic error codes:
ATTENTION! If an error code is encountered, an audio warning
signal is generated and the red Off signal light goes on in the dis-
play field. First, please try to continue operation by turning the
device off and back on again.If it is still not possible to eliminate
an error after an extended wait, please contact our service
department. If you do so, you should always tell us what error
code has been encountered. This simplifies the process of
tracking down the error and makes it possible to form a prelimi-
nary opinion.
032007
160 240 320 400 480 560 640
160
240 320 400 480 560 640
Error code
Off - LED (red)
1x flash /
2 sec pause
Off - LED (red)
2x flash /
2 sec pause
1/min
720 800
Off - LED (red)
3x flash /
2 sec pause
Off - LED (red)
4x flash /
2 sec pause
1/min
Off - LED (red)
720 800
5x flash /
2 sec pause
Off - LED (red)
6x flash /
2 sec pause
Off - LED (red)
7x flash /
2 sec pause
Off - LED (red)
8x flash /
2 sec pause
Error Cause of the error
The potentiometer for -Too rapid a change in the
the speed is not assig- speed target value
ning any target value -Internal device error
Permissible motor tem- -Permissible supported
peratur exceeded weight exceeded
-Permissible ambient
temperature exceeded
Motor locked -Agitation table is being
hindered in this stroke mo-
tion by an outside effect
Read fork signal not -Internal device error
available
Maximum adjustable -Resonance behavior of
speed of the device the experiment setup
exceeded
Motor standstill for de- -When turning on the
vice switch-on proce- device, you must ensure
(safety confirma- that the motor is not
dure
tion not ensured performing any rotational
motion
Safety relay cannot -Internal device error
be activated
The switch for the TIME -Internal device error
function is not assigning
any target value
Problem with the power -The device is beeing
supply operating with under vol-
tage or overvoltage (for
permissible voltage range,
see technical data)
Triac cannot be activated -Internal device error
29