Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents
Warranty
Safety instructions
Communication between laboratory instrument and PC
List of spare parts / Spare parts diagram KS130 basic
List of spare parts / Spare parts diagram KS130 control
Safety instructions
In order to be able to use the appliance properly and safely, every
user must first read the operating instructions and observe the
safety instructions contained therein. Take care of these operating
instructions and keep them in a place where they can be accessed
by everyone.
Only staff who have been trained accordingly, know the appliance
and are authorised to carry out work in this field should use this
032007
appliance.
The machine may only be opened by trained specialists - even
during repairs. The machine is to be unplugged from the mains
Page
before opening. Live parts inside the machine may still be live for
2
some time after unplugging from the mains.
19
NOTE !
20
removed from the unit without accessory equipment have
21
to be reattached to the unit for safe operation in order to
21
prevent, for example, the ingress of fluids, foreign matter, etc. .
21
When working with the shaking unit, the user must select and
22
wear his personal protective equipment according to the mixing
22
hazard category.
Defective or inadequate protective equipment
23
can expose the user to the risk
26
of spurting liquids, projectile
27
parts or being pulled in at the
28
shaking table or support.
28
Never touch moving parts (risk
29
of crushing, impact and cut-
30
ting, see fig. 1: Danger zones).
32
Ensure that parts of the body,
33
hair or items of clothing cannot
33
be trapped by the motion
34
parts.
34
Please follow the relevant
52/53
safety instructions and guideli-
54/55
nes, and occupational health
and safety regulations for use
in the laboratory.
Beware of the high dead
weight of the appliance when
transporting. Ensure that your
fingers do not get crushed when setting down the appliance.
Always install the appliance on a flat, stable non-slip base.
Before use, please ensure that the knob for setting the shaking
rate is at the left stop as the appliance starts up at the last shaking
rate which was set. Pay attention to the vessels on the shaking
table when setting the shaking rate. This will prevent any of the
Covering or parts that are capable of being
fig. 1 danger zones
19
Publicité
Chapitres
Table des Matières
