Switching On; Display - IKA KS 130 basic Mode D'emploi

Switching on

The device can be turned with the flip switch A on the front
side of the unit. After you have turned on the power switch to
position I, all light diodes of the basic variant will light up for a
brief time in the display windows as a self-test that follows.
The red light diode in the TIME LED line and the OFF mode of
the device light (audio signal).
For the control unit, all elements of the display will flash brief-
ly and the selftest operation will be shown on the display. All
important safety functions will be tested. The appliance is ope-
rable after this check.

Display

Desciption of the LED-Display - KS 130 basic
Display element for the setting speed
Mot 1/min 50 100 150 200 250
On Off 5 10 15 20
Continous Standstill
operation
The basic model of the device can be used in continuous or
timed mode depending on the option you select. The right turn
button is used to make the setting.
Contnuous operation: The device does not interrupt the agi-
tation sequence
22
300 350 400 450 500
50
25 30 35 40 45 Time min
Display element for
the setting agitation time
(On-LED is lit).
Time operation: The device interrupts the agitation pro-
cess after a set amount of time (max.
50 minutes).
The speed required for the agitation process can be adjusted
before or after the operating mode is selected.
The KS 130 basic is adjusted so that after you press the power
switch, the agitation process (speed) and time mode is turned
off (Off-LED lights up).
Desciption of the LCD-Display - KS 130 control
Real value
S S V V S S V V
= et alue
P P V V
(Rated value)
= =
= Locking
Mode of operation A: Star out
Mode of operation B: Star on
Mode of operation C: Star flash
Rated value
P P V V
= rocesst alue
(Real value)
e.g. phys. unit
mode of operati-
on, error code
032007