IKA KS 130 basic Mode D'emploi page 24

I 3 0
I 3 0
I
/
m i n
PV
Operating mode B:
When the device is turned on, target values for speed and time
setting are adopted before the device is turned off (power OFF).
The upper speed limit that has been set is taken over from ope-
rating mode A when this operating mode is selected and cannot
be modified.
When you turn on the device with the power switch, a B is
shown on the display for operating mode B along with * in the
right display. After the power has been turned off,the device will
no longer automatically start up in operating mode B by itself.
After you have selected operating the mode and turned on the
device, the following process will be shown on the display.
a.) All display elements in the digital displays are activated for
about 2 seconds.
b.) The device type (left display) and operating mode (right dis-
play) displayed for about 2 seconds.
I 3 0
K S
c.) After this, the set (or stored) upper speed limit of the agitator
is shown in the left display with SAFE and OK for about 2
seconds. As long as the upper speed limit is being displayed, it
is not possible ti change the upper speed limit.
24
3 5 6 .
3 5 8 :
The stored time target value or the one that has just been set (for
example 3:58) is shown in the right display with the indication h
i
min and a flashing SV . The user can recognize that operating
n m i n
mode B is active by the star * in the display for the time set-
PV
ting.
d.) The new speed target value has been set or just stored in the
left display (for example 130) is the shown in the unit 1/min and
flashing SV .
e.) By pressing the left or right turn button, you can place the agi-
tator in operation with the stored value or the one that has just
been set. The speed and time values are then shown in large for-
mat on the display. In addition, the text PV is shown on the dis-
play instead of SV . The actual value of the time setting must
be understood from this point onward as the time remaining for
the agitation process. If the time remaining has reached zero, the
agitator stops its motion.
B
,
Operating mode C:
The upper speed limit that has been sett is taken over from ope-
rating mode A when this operating mode is selected and cannot
be modified. The target values from operating mode A or B are
2 3 0
S A F E
O K
I 3 0
I
/
m i n
SV
3 5 6 .
I 3 0
I 3 0
I
/
m i n
PV
3 5 8 :
i
n m i n
SV ,
3 5 8 :
i
n m i n
SV ,
3 5 8 :
i
n m i n
,
PV
032007