Oase HeatUp 25 Notice D'emploi page 9

different-coloured temperature controller. There
are 3 fixed positions in the plus and minus range.
Each position corresponds to approx. 1° C.
NOTE
Do not attempt to go outside the calibration range.
How to proceed:
E
• Use a screwdriver for the calibration or break the
supplied tool out of the holder.
• Measured temperature is too high: Keep the
temperature controller at the set value and move
the calibration controller in the direction of -
(minus).
• Measured temperature is too low: Keep the
temperature controller at the set value and move
the calibration controller in the direction of + (plus).
TROUBLESHOOTING
This appliance has no user serviceable inner parts, or
equivalent
Issue
The water
does not heat
up.
Water does
not reach
the set
temperature.
Cause
No mains voltage
Unit defective
Insufficient water
circulation
Unit is not calibrated
The heating capacity of
the unit is not sufficient
with regards to the
ambient temperature
or water volume to be
heated up.
- EN -
Solution
Check the mains
voltage.
Replace unit
Check the
temperature
Calibrate the unit
Select a suitable
unit.
9