Oase HeatUp 25 Notice D'emploi page 7

• Position the unit with the heating element
pointing towards the floor of the aquarium on a
clean, smooth surface in an area with good water
circulation.
COMMISSIONING/START-UP
!
C AUTION
Risk of injury from hot surface!
Risk of burning parts of the body or risk of fire
• Disconnect the heater from the mains and allow it to
cool down before commencing any work.
NOTE
For the use of the heater in a filter approved for
this purpose:
Danger of fire! The heater and filter can be
destroyed by the heat generated at the surface
• Do not switch the heater on until the filter is
completely filled with water, switched on and
the water is continuously circulated.
NOTE
For use in an aquarium:
• Before switching on, ensure that the heater is
immersed in water at least up to the marking for
the minimum immersion depth.
NOTE
• Switch off the heater and allow it to cool down
before removing it from the water.
• Do not leave the heater unattended after
removing it from the water.
• Wait approx. 30 minutes before switching on so
that the thermostat can adjust to the temperature
of the water.
- EN -
7