Commissioning Of The Device; How To Install The Batteries - STEAMAX PROCOLOR MIT TFV8 BIG BABY CLEAROMIZER Manuel D'utilisation

STEAMAX PROCOLOR – COMMISSIONING OF THE DEVICE
Operating Instructions
Fully charge the two necessary and replaceable 18650 batteries before first use. Please take note of the
positive and negative poles in the battery compartment. Ensure that there is no visible damage to the surface
of the battery cells. The device has a 510-pin connection with a spring-loaded connector, making it suitable
for a variety of sub-ohm-capable clearomizers.

How to install the Batteries

Open the battery compartment by lightly pulling up the cover. Then place the two charged 18650 batteries in the
device according to the poles indicated. Close the battery compartment.
70
www.steamax.com
Note: If the display does not light up after switching the device
on, make sure that you have inserted the batteries correctly and
that they have sufficient power. If the device still cannot be swit-
ched on despite fulfilling all the aforementioned prerequisites,
please contact our customer service department.