Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
CAPACITANCE
1. Insert RED test lead into VΩ jack
COM jack
4
Continuity/Resistance/ Capacitance/Diode-Test
2. NOTE: The meter defaults to Continuity testing in this mode.
Press the SEL button
Capacitance icon
Black lead Red lead
3. Remove power from circuit.
4. Measure capacitance by connecting test leads across the capacitor.
The meter will auto-range to display the measurement in the most
appropriate range.
DIODE TEST
1. Insert RED test lead into VΩ jack
COM jack
4
Continuity/Resistance/ Capacitance/Diode-Test
Black lead Red lead
NOTE: The meter defaults to Continuity testing in this mode. Press
the SEL button
Diode icon
2. Touch test leads to diode. A reading of 200-800mV on display
indicates forward bias, "OL" indicates reverse bias. An open
device will show "OL" in both polarities. A shorted device will
show approximately 0mV.
FREQUENCY / DUTY-CYCLE
1. Insert RED test lead into VΩ jack
COM jack
Frequency/Duty-Cycle
14
OPERATING INSTRUCTIONS
, and rotate function selector switch
9
will appear on the display.
, and rotate function selector switch
three times to enter Diode testing mode. The
9
will appear on the display.
, and rotate function selector switch
4
, and BLACK test lead into
5
twice to enter capacitance mode. The
, and BLACK test lead into
5
and BLACK test lead into
5
setting.
to the
2
setting.
to the
2
setting.
to the
2
Publicité
Table des Matières
