Klein Tools CL2000 Manuel D'instructions

Instruction Instruction
Manual Manual
CL2000
ENGLISH
• TRUE RMS
• RELATIVE / ZERO
• BACKLIGHT
• WORKLIGHT
• BAR GRAPH
• MAX / MIN / HOLD
• 3-3/4 DIGIT
3999 COUNT LCD
• AUTO / MANUAL
RANGE
• NON CONTACT
VOLTAGE TESTER
TRMS
www.kleintools.com
All manuals and user guides at all-guides.com
CL2000
0 10 20 30 40
ENGLISH
CL2000
Instruction Manual
GENERAL SPECIFICATIONS
The Klein Tools CL2000 is a True RMS, auto-ranging clamp meter.
It measures AC / DC voltage, AC / DC current, resistance, capacitance,
frequency, and duty cycle. It can also test non-contact voltage, diodes,
and continuity.
• 2000 meters
Operating Altitude:
• Humidity: 80% max
• Operating Temperature: 0°C / 32°F to 45°C / 113°F
• 0°C / 32°F to 60°C / 140°F
Storage Temperature:
• Accuracy Temperature: 18°C / 64°F to 28°C / 82°F
• Temperature Coefficient: 0.1*(specified accuracy) / °C
• 8.875" x 3.375" x 1.5"
Dimensions:
• Weight: 10.7oz.
• Calibration: Accurate for one year
• CAT Rating: CAT III 600V
• ± (% of reading + # of least significant digits)
Accuracy:
To ensure safe operation and service of the tester, follow these instructions.
Failure to observe these warnings can result in severe injury or death.
• Before each use, verify meter operation by measuring
a known voltage or current.
• Never use the meter on a circuit with voltages that exceed the
category based rating of this meter.
• Do not use the meter during electrical storms, or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Ensure meter leads are fully seated, and keep fingers away from
the metal probe contacts when making measurements.
• Do not open the meter to replace batteries while the probes
are connected.
• Use caution when working with voltages above 60V DC,
or 25V AC RMS. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock,
replace batteries if a low battery indicator appears.
• Unless measuring voltage or current, shut off and lock out
power before measuring resistance or capacitance.
• Always adhere to local and national safety codes. Use individual
protective equipment to prevent shock and arc blast injury where
hazardous live conductors are exposed.
SYMBOLS
~
AC Alternating Current
DC Direct Current
DC/AC Voltage or Current
Ground
AC Source
WARNINGS
Warning or Caution
Dangerous levels
Double Insulated Class II
Safe for disconnect
from live conductors