Elettro CF PRO MIG 565 TWO-PULSED Manuel D'instructions page 14

wire speed (LED U1),
Current (LED T1).
- conventional MIG:
wire speed (LED U1)
- TIG and MMA :
current (LED T1)
In the service functions select the functions indicated by the
abbreviations: H2O, HSA, FdP, ddP, tdP, AdP, CP, rob, FAc.
NOTE: in synergic programs, adjusting one size will also vary
the others consequently.
Button R1
Each press selects the value adjustable via the knob X.
The values that may be selected are in relation to the type of
welding process selected.
LED V1 Thickness
The display S1 shows the recommended thickness based on the
current and wire speed set. Active in synergic MIG welding.
LED U1 Wire speed
Indicates that the display S1 shows the welding wire speed.
Active in all MIG welding operations.
LED T1 Current
Indicates that the display S1 shows the preset welding current
or, in combination with the lighting of the LED S, the actual
welding current. Active in all welding processes.
Knob Y
In relation to the type of process selected, this knob is used to
adjust the following values:
- synergic pulsed MIG and synergic MIG:
length of the arc (E2 LED)
Impedance (F2 LED)
- conventional MIG:
Welding voltage (D2 LED)
Impedance (F2 LED)
- Within the saved programs select the desired program number.
All of these values are shown on the display (C2) and are
selected by the button B2.
In the service functions select the abbreviations: OFF, OnC,
OnA, SAu, rES, On.
Button B2
Each pressure selects the value adjustable via the Knob Y.
The values that may be selected are in relation to the type of
welding process selected.
LED D2 Voltage
In all MIG welding processes, indicates that the display C2
shows the preset voltage or, in combination with the lighting of
LED S, the actual welding voltage.
in TIG and MMA modes it always remains lit, and may not be
selected. IIndicates that the Display C2 displays the open-circuit
voltage or welding voltage or, in combination with LED S lit, the
actual welding voltage.
LED E2 Arc length
Adjustment -9,9 ÷ +9,9.
In all synergic MIG programs the display C2 shows a number.
Zero is the manufacturer setting; if the number is set to negative,
the arc length diminishes, if set to positive it extends.
LED F2 Impedance
Adjustment -9,9 ÷ +9,9.
In all MIG programs the display C2 shows a number. Zero is the
manufacturer setting, if the number is set to negative impedance
it decreases, and the arc becomes harder; if it increases, the arc
becomes softer.
LED X1 globular position
May not be selected. Active in non-pulsed synergic MIG mode.
When this occurs, it signals that the pair of values selected for
14