Laica NE1005 Instructions Et Garantie page 49

Guidance and manufacturer's declaration
electromagnetic immunity
The NEBULIZER MODEL NE1005 is intended for use in the electromagnetic environment
specified below. The customer or the user of the NEBULIZER MODEL NE1005 should assure
that it is used in such an environment.
Immunity test IEC 60601 Compliance
test level level
Conducted RF 3 Vrms 3 Vrms
IEC 61000-4-6 150 kHz to 80 MHz
Radiated RF 3 V/m 3 V/m
IEC 61000-4-3 80 MHz to 2.5 GHz
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
a. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and
land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted
theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters,
an electromagnetic site survey should be considered. If the measured field strength in the location in
which the NEBULIZER MODEL NE1005 is used exceeds the applicable RF compliance level above, the
NEBULIZER MODEL NE1005 should be observed to verify normal operation. If abnormal performance
is observed, additional measures may be necessary, such as re-orienting or relocating the NEBULIZER
MODEL NE1005.
b. Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
E l e c t r o m a g n e t i c e n v i r o n m e n t
-guidance
Portable and mobile RF communications
equipment should be used no closer to any
part of the NEBULIZER MODEL NE1005,
including cables, than the recommended
separation distance calculated from the
equation applicable to the frequency of
the transmitter.
Recommended separation distance
where P is the maximum output power
rating of the transmitter in watts (W)
according to the transmitter manufacturer
and d is the recommended separation.
Distance in metres (m). Field strengths
from fixed RF transmitters, as determined
by an electromagnetic site survey,a should
be less than the compliance level in each
frequency range. Interference may occur in
the vicinity of equipment marked with the
following symbol:
Recommended separation distances between
portable and mobile RF communications equipment and the NEBULIZER
MODEL NE1005
The NEBULIZER MODEL NE1005 is intended for use in an electromagnetic environment in which
radiated RF disturbances are controlled. The customer or the user of the NEBULIZER MODEL
NE1005 can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the NEBULIZER
MODELI NE1005 as recommended below, according to the maximum output power of the
communications equipment.
R a t e d m a x i m u m
Separation distance according to frequency of transmitter
output power
of transmitter
150 kHz to 80 MHz
W
0.01 0.12
0.1 0.38
1 1.2
10 3.8
100 12
For transmitters rated at a maximum output power not listed above, the recommended separation distance d
in metres (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is
the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
m
80 MHz to 800 MHz 800 MHz to 2.5 GHz
0.12 0.23
0.38 0.73
1.2 2.3
3.8 7.3
12 23