Installation; Preparation; Removal - Gazzini 10030234 Mode D'emploi

CAUTION!
Risk of accident!
• In order to use the mirror safely, it must always be installed on the
motorcycle in such a way that it gives the rider an adequate view
of following traffic.
• The mirror must be securely mounted because if it were to fall
off, it would pose a hazard to other road users and could cause
accidents.
• You must also ensure that the mirror never makes contact with
other parts of the vehicle (fairing, tank etc.) or impede the rider in
any way, even when the handlebar is turned to full lock.
• When installing the mirror stem on the handlebar end, you must
ensure that it does not prevent the throttle twistgrip from moving
freely. The twistgrip must be able to spring back by itself from
any position when you release it.
CAUTION!
Risk of injury!
• When installing the product, ensure that the vehicle cannot topple
over and that the workplace is well lit.
IMPORTANT!
Risk of damage!
• After installation and before every journey, check that the mirror
is secure and adjusted properly.

4 | Installation

4.1 | Preparation

Place the vehicle securely on its stand and make sure that there is sufficient lighting
in the workstation.

4.2 | Removal

If necessary, remove the existing bar-end mirror or bar ends. Check whether the han-
dlebar has freely accessible, open bar ends with an inner diameter of 13.5 - 21 mm.
12