Light Indicators - Milwaukee MXFC Notice Originale

As a general practice, it is best to unplug battery chargers and
remove batteries when not in use. No battery pack damage will
occur, however, if the charger and battery pack are left plugged in.
The charger will keep the battery pack fully charged if it is left on
the charger. The light indicator will be same as normal charging.
If the light indicator fl ashes red and green, check that the battery
pack is fully seated into the bay. Remove the battery pack and
reinsert. If the light continues to fl ash red and green, remove
pack(s) and unplug charger for at least 2 minutes. After 2 minutes,
plug charger back in and insert pack. If the problem persists,
contact a MILWAUKEE service facility.

LIGHT INDICATORS

Continuous red
Slow fl ashing green
Continuous green
Fast fl ashing red
Flashing red/green
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance
with local, national and international provisions and regulations.
• The user can transport the batteries by road without further
requirements.
• Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and insulated
to prevent short circuit.
• Ensure that battery pack is secured against movement within
packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
If the supply cord of this appliance is
damaged, it must only be replaced by
a repair shop appointed by the
manufacturer, because special
purpose tools are required
Use only Milwaukee accessories and Milwaukee spare parts.
Should components need to be replaced which have not been
described, please contact one of our Milwaukee service agents
(see our list of guarantee/service addresses).
470 355 - MXFC.indd 9 470 355 - MXFC.indd 9
Charging
Approaching full charge
Charging is complete
Battery or charger is too hot/cold
- charging will begin/resume
when battery or charger reaches
correct charging temperature
Damaged or faulty battery pack
or charger
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on the
label and order the drawing at your local service agents or directly
at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
Do not burn used battery packs.
Never charge a damaged battery pack.
Replace with a new one.
Do not dispose electric tools, batteries/rechargeable
batteries together with household waste material.
Electric tools and batteries that have reached the end
of their life must be collected separately and returned
to an environmentally compatible recycling facility.
Check with your local authority or retailer for recycling
advice and collection point.
This tool is only suitable for indoor use. Never expose
tool to rain.
Double insulated
European Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH 9
27.05.2020 10:04:49 27.05.2020 10:04:49