Safety Warnings - Astralpool LUMIPLUS PAR56 1.11 Manuel D'installation Et D'entretien

6. SAFETY WARNINGS:

• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS.
• All maintenance operations should be performed with the projector disconnected from the Mains.
• Do not handle with wet feet.
7. ASSEMBLY AND FUNCTIONING WARNINGS:
THE HOLES AT THE BACK OF THE LAMP 2.0(FIG. 10) SHOULD BE LEFT FREE WHEN ASSEMBLING THE PROJEC-
TOR, SO THAT WATER CAN FLOW INSIDE FOR OPTIMUM PERFORMANCE OF THE LAMP.
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The projector is designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• The STD projector is not designed to work submerged in seawater.
• The Global projector is seawater resistant.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the
following levels:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
TYPE OF TREATMENT
ATTENTION
CONCENTRATION IN WATER
4
2 mg/l
5 mg/l
6 g/l