Automatic Ice And Water Dispenser - IKEA STJARNSTATUS Mode D'emploi

AUTOMATIC ICE AND WATER DISPENSER

EN
Priming the water supply
system
CAUTION
For proper dispenser operation,
recommended water supply pressure
should fall between 30 psi and 100 psi.
Excessive pressure may cause the
system to malfunction.
1 Begin filling the system by pressing
and holding a drinking glass against
the water
dispenser
paddle.
2 Keep the
glass in this
position until
water comes
out of the
dispenser.
It may take
about 1½
minutes.
3 Continue
dispensing
water for about four minutes to
flush the system and plumbing
connections of any impurities
(stopping to empty the glass as
necessary).
NOTE
The water dispenser has a built-in de-
vice that shuts off the water flow after
three minutes of continuous use. To
reset this shutoff device, simply release
the dispenser paddle.
NOTE
Dispensed water is not chilled. For
colder water, add ice to cup or con-
tainer before dispensing water.
Ice maker operation & care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can produce ice within 24 hours.
The ice maker will fill the ice bin from
the rear. You must dispense some ice to
force the ice forward in the bin. This will
allow the bin to fill completely.
Dispenser
(varies by model)
Ice Maker and Storage Bin
Capacity
This ice maker should produce 2.0 to 2.5
pounds of ice per 24 hours.
In a Standard Depth model, the ice bin will
hold about 6.5 pounds of ice. In a Counter
Depth model, the ice bin will hold about 4
pounds of ice.
Turning the fresh food ice
maker on and off
Ice production is controlled by the ice
maker's On/Off feature on the control
panel. Pressing the On/Off feature turns
the ice maker on & off.
IMPORTANT
Turning off the ice maker simply dis-
ables ice making. You will still be able
to dispense existing ice, and you will
still be able to dispense water.
NOTE
The ice maker also has a built-in plas-
tic signal arm that automatically stops
ice production when the ice bin is full.
This signal arm should not be used to
manually stop the ice maker.
Using the ice maker after
installation
Before making ice for the first time,
be sure to prime the water supply
system. Air in new plumbing lines can
result in two or three empty ice maker
cycles. Furthermore, if the system is
not flushed, the first ice cubes may be
discolored or have an odd flavor.
IMPORTANT
Your ice maker is turned on at the
factory so it can work as soon as you
install your refrigerator. If you can-
not connect a water supply, set the ice
maker's On/Off feature to Off; oth-
erwise, the ice maker's fill valve may
make a loud chattering noise when it
attempts to operate without water.
21