IKEA STJARNSTATUS Mode D'emploi page 8

INSTALLATION
CAUTION
Do Not loosen or remove these 3 hex
screws.
Cabinet Leveling &
Refrigerator Door Alignment
(if necessary)
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must
rest firmly on the floor.
• The front should be slightly elevated
to ensure that doors close and seal
properly.
• Doors should align with each other
and be level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front
rollers:
1 Slightly open freezer drawer if the
toe grill is installed. Lift the toe grille
and gently pull forward.
2 Make initial cabinet adjustments by
using the front roller height adjusting
screws. Use a 3/8 inch socket wrench
to turn the adjustment screws (1 per
side).
8
DO NOT
Loosen
or
Remove
These 3
Hex
Screws
3 Ensure both doors are bind-free with
4 After unit is leveled, lower anti-tip
5 Install the toe grille by fitting into
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
Anti-tip
Leg
their seals touching the cabinet on all
four sides and that cabinet is stable.
leg using a 3/8 inch socket wrench
until it firmly contacts the floor.
place.
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(2) Retaining Clips
EN
Raise
Lower