Components; Accessory Parts - Panasonic TY-VK55LV1 Instructions D'installation

Components

Accessory parts

Ⓐ Mount bracket screws
※
(M6×16)(4)
Ⓓ Main unit fi xing screws (2) Ⓔ Hexagonal wrench
Ⓖ Surface alignment magnets
(a)
Ⓗ Plates
TY-VK47LV1 (4)
※ The TY-VK55LV1's M6 screws are included in the same package.
♦ Store small parts appropriately and out of reach of children.
♦ The images shown in this manual are for illustrative purpose only.
♦ The product specifi cations may be changed at any time without prior notice.
Precautions for Installation Mount fi tting
♦ Do not let people other than installation specialists carry out the installation work. Incorrect fi tting may cause
equipment to fall, resulting in injury.
♦ This unit is an installation mount for installing the main unit vertically.
Do not use it in places that are not vertical.
♦ To ensure correct display performance and prevent trouble, do not fi t at any of the following locations.
• Near sprinklers or fi re/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
♦ Fit using techniques suited to the structure and materials of the fi tting location.
♦ Use commercially available screws that are suited to the wall material (wood, steel frame, concrete etc.) you
are fi tting the installation mount to.
♦ For the display power supply plug, use a power supply outlet that can be reached easily.
♦ Ensure good air fl ow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to
do this may cause heat to build up inside the display, resulting in malfunction.
♦ Spread a soft blanket or cloth over the fl oor so that the display and fl oor will not be marked or scratched
during the assembly and installation work.
♦ When screwing down the parts, ensure that the screws are neither insuffi ciently tightened nor over tightened.
♦ Take suffi cient care to ensure safety around you when performing the assembly and installation work or while
moving about during the course of the work.
♦ Do not install the display underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise, the cabinet
may be bent or damaged by high heat.
To the Installation Contractor
♦ If the installation mount installation and display installation work are performed by different contractors,
please ensure that this manual is passed from the installation mount installation contractor to the display
installation contractor after the installation mount installation work is completed.
♦ Please give this manual to the customer after the installation work is completed.
26
(Illustration created based on TY-VK55LV1)
Ⓑ Magnet fi xing screws
TY-VK55LV1
(M4×16)(8)
(M6×16)(8)
TY-VK47LV1
(M4×16)(8)
(included tool) (1)
5 mm
(b) (c)
Check that all the parts are accounted for and
present in their designated quantities.
Ⓒ Frame linking screws
(M6×70), nuts, fl at
washers and spring
※
washers (four each)
Ⓕ Mount bracket (2)
Installation mount
(d)