DeVilbiss Healthcare PULSEDOSE COMPACT PD1000 Guide De L'utilisateur page 10

SYMPTOMS
PulseDose will not pulse
PulseDose works fine for a
couple of minutes, then
sensitivity seems to drift and
may stop working altogether.
Green and Red LED's do not
illuminate when the unit is
turned "ON".
Red light flashes when breath
is detected.
Red light stays on
continuously. Unit will not
pulse.
SPECIFICATIONS
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14.7 ounces; 16.3 ounces with battery
Dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.75"L x 3.4"W x 2.8"H (12.06 cm L x 8.64 cm W x 7.11 cm H)
Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (2) Standard "AA" alkaline or NiMH batteries.
Operational Voltage Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.3 to 3.6V DC
Power Requirements . . . . . . . Average steady state "ON" current 1.6 uA. Batteries other than alkaline or NiMH
Degree of Protection Against Electric Shock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TYPE BF applied part
Modes of Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Continuous / Pulsed
Operating Temperature Range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14° to 104°F (-10° to 40°C)
Operating Pressure Range. . . . . . . . . . . . . . . . . . . . . . . . . . . .500 to 2250 PSIG (34 to 155 bar—tank pressure)
Operating Atmospheric Conditions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500 to 1020 hPa
Operating Humidity Range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to 95% R. H. non-condensing
Storage and Transportation Temperature Range (Tested at ~933 hPa) . . . . . . . . . .-40° to 158°F (-40° to 70°C)
EN - 10
POSSIBLE CAUSES
1. Cannula is not attached
properly.
2. Unit is not turned on.
3. Batteries discharged or not
installed.
4. Mouth breathing with closed
soft palates.
5. Unit did not reset while
changing batteries (red light
stays on).
1. Using pediatric cannula or
any cannula that restricts
continuous flow capacity of 10
lpm.
1. Batteries discharged or not
installed.
2. Unit defective.
1. Battery charge is low.
1. Battery charge is depleted.
are not recommended due to the capacity needed for operation and battery life of
the unit. Typical new battery life is 200 hours when used at 25°C, 2 LPM and 20
BPM. Settings and breath rate will affect battery life. After the Low Battery (flash-
ing red) light illuminates, the unit will continue to operate about four hours when
used at 25°C, 20 BPM and the 6 LPM setting. Settings, breath rate, and battery
conditions will affect use times. Refer to local regulations for battery recycling and/
or disposal requirements.
REMEDIES
1. Check all cannula connections to make
sure they are tight, and adjust the cannula
to fit comfortably in your nose. Ensure
tubing is not kinked.
2. Turn the rotary selector to the
appropriate setting.
3. Install new batteries.
4. Breathe through the nose (cannula).
5. Turn the unit off and back on using the
rotary selector.
1. Replace with standard nasal cannula.
1. Install new batteries.
2. Contact your DeVilbiss Provider.
1. Replace/recharge (when applicable)
batteries.
1. Replace/recharge (when applicable)
batteries.
A-1000