Continuous Rotary File Systems; My Program For Continuous Rotary File Systems - Dentsply Maillefer wave-one Mode D'emploi

6.6.2. Continuous Rotary File Systems

When a file system has been selected, the first file of the system will automatically be shown in
the display.
Press the  key to move the arrow to the field "File". There is no need to confirm this
selection. Simply press the foot pedal to drive the file.
Press the + key to select the next file.
Press the – key to select the previous file.
NOTE
 For the PathFile
™
have the same settings and individual files can't be selected.
 For certain systems, a file range is displayed (e.g. 15-40). This means that all the files
within the file range have the same settings and individual files can't be selected.

6.6.3. My Program for Continuous Rotary File Systems

For convenience, the device is delivered with 15 default values of torque and speed (for details
see the default values´ table for torque and speed on page 29). To individually change these
settings simply "overwrite" them as described below. This allows you to compile your own
instrument sequence independently from file manufacturer or recommended sequences. To
return to default settings see chapter 6.7.
The settings can be changed in the same way as for the other rotary file systems.
For recording your individual settings, see table on page 29.
system, "ALL" is displayed. This means that all the files of the system
www.enversaltan.com
www.enversaltan.com
- 21 /141 -