Preparation; Installation; Power Supply - Dentsply Maillefer wave-one Mode D'emploi

6.2.

Preparation

1. Carefully remove the device and the accessories from their packaging and place them on a
flat surface.
2. Check that all the components listed in the STANDARD COMPONENTS chapter (see
chapter 6.1) are present.
3. Check that the device serial number as stated on the bottom label of the central unit, the
serial number on the outer carton and the number reported in the shipping documents are
the same.
WARNING
Should any liquid exit the device, interrupt the installation immediately and send the machine
to your distributor.
6.3.

Installation

6.3.1. Power Supply

1. Select the plug adapter that matches your electric power outlet for the power supply.
Place the required plug adapter on the two contacts on the power supply and push it toward
the locking button (B) until it snaps into place. You must press the locking button (B) to change
the adapter (See Fig. 1).
NOTE
The connectors are coded.
Therefore, make sure that the connectors are correctly oriented when plugging them together.
www.enversaltan.com
www.enversaltan.com
Fig. 1 Plug adapters for power supply
- 9 /141 -