Micromotor - Dentsply Maillefer wave-one Mode D'emploi

A
The WaveOne endo motor is provided with an USB socket for exclusive use by an authorized
™
service center for maintenance purposes or software updates. This USB socket is covered by
an "ONLY FOR SERVICE DO NOT REMOVE" label upon delivery.
2. Charge the battery before the first use (see chapter 6.3.3):
a. Connect the battery charger to the mains.
b. Insert the connector of the battery charger in jack connector (A – see Fig. 2) on the back
of the device (for details see chapter 6.3.3).
c. Completely charge the battery prior to first use.
d. Plug the foot pedal cable in jack connector, located on the back of the device (C – see
Fig. 2).
WARNING
To disconnect the cables, always hold at the central part of the connector and pull out. Do not
pull the cable.

6.3.2. Micromotor

1. Insert the micromotor connector into the 9-pin metal socket (B – see Fig. 3) at the front of
the device.
www.enversaltan.com
www.enversaltan.com
Fig. 2 Back of central unit
C
Fig. 3 Metal socket
- 10 /141 -