Setup And Commissioning - STEINEL NM 5000-2-24 Consignes D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10
F
rio
ht
OF
Va
Nig
ON
F
ng
OF
rni
Mo

Setup and Commissioning

Light level setting (response
threshold)
OFF ON
Vario OFF
Morning
Night
OFF ON
Vario OFF
OFF ON
Vario OFF
Morning
Night
Morning
t
0,5 – 100 Lux
(factory setting:
darkness operation
approx. 5 lux
OFF ON
0,5 – 100 Lux
Morning
The light level setting sets the level
at which lights will turn on and off.
The setting is concealed behind
the decorative faceplate.
• Place sensor in programming
mode:
- Press the programming
button. Lights will turn off
and the sensor function is
deactivated.
www.steinel.net
(800) 852-4343
• Select the light level setting
- At the light level at which
OFF ON
Vario OFF
OFF ON
Vario OFF
Morning
t
Morning
Night
you want the NM 5000-2-24
to switch connected load(s)
on, press the button until
OFF ON
Vario OFF
the red LED (behind the
Morning
Night
OFF ON
Vario OFF
Morning
Night
transparent housing) flashes.
- Release button, the new
ON level will be saved after
Vario OFF
Night
approximately 5 seconds.
• Important: While setting the
light level, do not cover it or
shade it with your own shadow.
• The last setting will remain
stored in the memory in the
event of a power failure.
• To reset to factory setting
(approx. 5 lux)
- Keep the button pressed for
approximately 5 seconds
until the red LED stops
flashing. The LED goes
on and Control is on for
approximately 3 minutes.
Setup and Commissioning
Setting night economy mode
LED
OFF ON
Vario OFF
Morning
Night
0,5 – 100 Lux
OFF
ON
Vario OFF
Morning
Night
24
24
=
0,5 – 100 Lux
=
21
3
21
6
6
No night,
Medium night,
economy
economy
mode
mode
Night economy mode
automatically turns lights off at
specified times of the night when
lighting is not needed.
The night economy mode always
ends in the early hours of the
morning between approximately
4:00 and 5:00 a.m. The light then
switches on again when it gets
dark if the setting for morning
hours is in the ON position.
Factory setting is for the light
to switch OFF at approximately
1:30 a.m. (There is no clock in
the electronics.
All time values are computed
by the microprocessor on the
basis of ambient light levels at
0,5 – 100 Lux
F
OF
Va
rio
Nig
ht
ON
F
rni
ng
OF
Mo
OFF ON
Vario OFF
OFF ON
Vario OFF
OFF ON
Morning
Night
Morning
t
Morning
OFF ON
OFF ON
Vario OFF
OFF ON
Vario OFF
Morning
t
Morning
Night
Morning
(factory setting:
Light ON in the
morning)
OFF ON
Vario OFF
24
=
Morning
Night
3
21
3
OFF
OFF
6
Long night,
economy
mode
twilight. Seasonal changes in light
levels are automatically taken into
account.)
Setting for morning hours
When the morning setting is
counterclockwise (OFF), lights
will stay off in the morning. Fully
clockwise (ON) will have lights
OF
F
Va
rio
ht
Nig
ON
F
ng
OF
Mo
rni
turn on in the morning between
approximately 4:00 and 5:00
a.m. and remain on until the set
OFF ON
Vario OFF
OFF ON
Vario OFF
Morning
Night
Morning
brightness level is achieved.
0,5 – 100 Lux
OFF ON
Vario OFF
OFF ON
Vario OFF
OFF ON
Vario OFF
Morning
Night
Morning
t
Morning
Night
(factory setting: OFF at
approx.130 a.m.)
www.steinel.net
(800) 852-4343
OFF ON
Vario OFF
Morning
11
Vario OFF
Night
Vario OFF
Night
OF
F
rio
ht
Va
Nig
ON
F
OF
rn ing
Mo
OFF ON
t
Morning
OFF ON
Morning
Night

Publicité

Table des Matières
loading

Table des Matières