Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
Installation
Ceiling mount installation with
threaded nipple
• Run low voltage wires from the
sensor through the provided
threaded nipple and snap
threaded nipple in back of
sensor
• Cut 7/8" hole in ceiling tile
• Place threaded nipple through
the hole in ceiling tile, add
washer and secure with locknut
• Wire sensor to STEINEL power
pack
www.steinel.net
(800) 852-4343
Wall mount installation
• Remove decorative cover
• Remove screws securing the
front and back housings
• Separate the top housing from
the back housing
• Fasten the back housing to the
wall with screws through pre-
punched holes
• Connect low voltage wiring to
STEINEL power pack
• Reattach the front housing to
the back housing and secure
with screws
• Snap the decorative cover back
in place
Operation
This photoelectric lighting
controller measures ambient
brightness and automatically
switches the light ON at dusk and
automatically OFF as programmed
with the various switching options.
www.steinel.net
(800) 852-4343
7
Publicité
Table des Matières
