Cleaning And Maintenance - STEINEL L 605 S Mode D'emploi

– Night light ON as from a selected
brightness response threshold until
the middle of the night.
The light contains no integrated clock.
The middle of the night is determined
by the length of the dark phases. The
power supply must not be interrupted
during the calibration phase.
– During the first night, the night light
remains activated throughout the
night. The values are saved even in
the event of a mains power failure.
– The values are determined over
several nights.
Programme 3
User-friendly programme:
– Soft light start.
– Night light, ON all night as from
a selected brightness response
threshold.
Programme 4
Nightmatic programme
NM
– Soft light start.
– No night light.
– No movement evaluation
Light is switched to 100% output when
ambient light level falls below brightness
response threshold.
Manual override (Fig. 5.2)
In manual override mode, the light stays
ON for 4 hours. Then it returns to sensor
mode. Manual override mode is activat­
ed at the mains power switch (pressing
within 0.2 to 1.0 second).
• Activate: 2 × OFF and 2 × ON.
• Deactivate: 1 × OFF and 1 × ON.
Adjusting the detection zone
To rule out inadvertent triggering or target
specific danger spots, the detection zone
can be limited with film shrouds. The film
shroud is stuck onto the sensor unit.
– Limit the detection zone's max. reach
with the top film shroud. (Fig. 5.3)
– Limit the horizontal detection zone
with film­shroud segments cut to
size. (Fig. 5.4/5.5)
6. Cleaning and
Maintenance
Hazard from
electrical power.
Contact between water and live parts can
result in electrical shock, burns or death.
• Light must not be wet­cleaned.
Risk of damage to property!
Using the wrong detergent can damage
the light.
• Make sure detergent does not harm
the surface.
• Clean light with a soft cloth and mild
detergent.
Important: The control gear is not
interchangeable.
17
GB