RDI CROSSOVER Directives D'installation page 5

7.
The post is now ready to accept the railing
installation (Fig. 11).
NOTE: Post caps should be glued on AFTER
installation is complete. Simply apply a
small amount of vinyl adhesive to the cap to
permanently secure.
* NOTE: If using RDI Metal Works
or Titan pro with a 4" x 4" post sleeve and
this structural post, the bracket screws
provided will interfere with the post.
It is recommended that you purchase
the Avalon Stair Hardware Pack (Part
#34114837) and use the #10x2" long flat
head square drive screws, pre-drilling with
an / " bit to attach the brackets to the post.
1
8
(Fig. 11)
Excalibur
®
5