Install The Battery Pack; Remove The Battery Pack; Operation; Important - GreenWorks Pro CSB401 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9. Install the chain cover.
10. Tighten the chain. Refer to
11. Tighten the nuts when the chain is correctly
tensioned.
NOTE
If you start the chain saw with a new chain, have a test
for 2-3 minutes. A new chain gets longer after the first
use, examine the tension and tighten the chain if
necessary.

11.3 INSTALL THE BATTERY PACK

WARNING
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.

11.4 REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
12

OPERATION

NOTE
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.

IMPORTANT

Examine the chain tension before each use.
English
Adjust the chain tension.
12.1 EXAMINE THE CHAIN
LUBRICATION
Do not use the machine without sufficient chain
lubrication.
1. Examine the lubricant level of the machine from the
oil indicator.
2. Add the lubricant if it is necessary.

12.2 HOLD THE MACHINE

1. Hold the chainsaw with your right hand on the rear
handle and left hand on the front handle.
2. Hold the handles with the thumbs and the fingers
around them.
3. Make sure that your left hand holds the front handle
and your thumb is below the handle.

12.3 START THE MACHINE

Figure
1. Press the on/off switch.
2. Press the lock-out button.
3. Press the trigger while you hold the lock-out button.
4. Release the lock-out button.

12.4 STOP THE MACHINE

1. Release the trigger to stop the machine.

12.5 OPERATE THE CHAIN BRAKE

WARNING
Make sure that your hands are on the handles at all
times.
9
NOTE
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

2000002

Table des Matières