Add The Bar And Chain Lubricant; Adjust The Chain Tension; Sharpen The Cutters - GreenWorks Pro CSB401 Manuel D'utilisation

EN
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
13.1 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level
is low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and
chain oilers.
The machine comes from the factory without bar and
chain lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt
gets into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.

13.2 ADJUST THE CHAIN TENSION

The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take
up the slack.
Tension the chain so that it can only just be pulled away
from the bar at its centre point.
A slack chain may jump off and cause serious or even
fatal injury.
Wear protective gloves if you touch the chain, bar or
areas around the chain.
1. Stop the machine.
2. Loosen the lock nuts with the wrench.
CAUTION
WARNING
IMPORTANT
NOTE
IMPORTANT
WARNING
CAUTION
English
It is not necessary to remove the chain cover to adjust
the chain tension.
3. Turn the chain adjustment screw clockwise to
increase the chain tension.
4. Turn the chain adjustment screw counterclockwise
to decrease the chain tension.
5. When the chain is at the wanted tension, tighten the
lock nuts.

13.3 SHARPEN THE CUTTERS

Sharpen the cutters if it is not easy for the chain to go
into the wood.
We recommend that a service center, which has an
electric sharpener, perform important sharpening
work.
1. Tensioning chain.
2. Sharpen the cutters corner with a 5/32 in. (4 mm)
diameter round file .
3. Sharpen the top plate, side plate and depth gauge
with a flat file.
12
NOTE
NOTE