Care And Maintenance; Technical Specifications - Kärcher SE 5.100 Manuel D'instructions

Dry vacuum cleaning
ATTENTION
Container and accessories must be dry, otherwise dirt
may adhere.
 Remove the wastewater and fresh water contain-
ers.
Illustration
 Recommendation: Insert the filter bag for vacu-
uming.
Illustration
 Use the adapter for wet/dry vacuuming Attach the
adapter to the handle, turn the locking handle to se-
cure it.
 Select the desired accessories and attach to the
spray/suction pipes or directly to the attachment.
 Switch on the vacuum.
Note: Do not switch on the spray.
Vacuuming of hard floors
Illustration
 Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of the
floor nozzle are extended.
Vacuuming carpeted floors
Illustration
 Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of the
floor nozzle are retracted.
 Use the surrounding air separator to adapt the suc-
tion force.
Note:
Close the surrounding air separator again after
use!
Vacuuming up moist dirt/water
ATTENTION
Do not use a filter bag!
 Remove the fresh and waste water containers, vac-
uum the wet dirt/water directly into the container.
 Use washing nozzle to vacuum up wet dirt/water.
 Once the wastewater container is full, the appli-
ance switches off automatically.
Note: Once the appliance shuts off, switch it off us-
ing the vacuum button, because the suction turbine
will otherwise start running again once you open
the appliance.
If you use a crevice nozzle:
 Attach and secure the adapter for wet/dry vacuum-
ing. Install the crevice nozzle directly to the adapt-
er.
 Switch on the vacuum.
Finish operation
 Turn off the appliance.
 Drain the full container.
 Rinse the reservoir thoroughly with clear water.
 Separate handle, spray suction pipes and washing
nozzle, in order to do so, open the locking lever
(central position).
 Flush the accessories separately under running
water and let air dry.
 Leave the appliance open to let it dry.
Illustration
 Accessories storage: Suction hose, suction
pipes and accessories can be comfortably stored
on the appliance.
 Storing the appliance. Store the appliance in a
dry room.

Care and maintenance

Clean the spray nozzle
With an uneven spray jet.
Illustration
 Loosen nozzle attachment and pull out, clean or re-
place spray nozzle.
Clean the sieve in the fresh water reservoir
1 x year or as needed.
Illustration
 Clean sieve.
Clean flat fold filter
For heavy contamination:
Illustration
 Unlock and open the cover, remove flat fold filter,
remove grid and brush off filter.
Troubleshooting
No water exiting from nozzle
 Fill up fresh water reservoir.
 Sieve in the fresh water container clogged.
 Thermal protection switch has switched off the
pump as it was overheated. Switch off appliance
and let it cool down (approx. 20 - 30 min).
 Detergent pump defective, contact customer ser-
vice.
Spray stream uneven
 Clean the spray nozzle of the washing nozzle.
Insufficient vacuum performance
 Close the surrounding air separator at the handle.
 Accessories, suction hose or suction tubes are
clogged, please remove the obstruction.
 Filter bag is full: Insert new filter bag.
 Flat fold filter is contaminated, use filter cleaning
mechanism, remove the flat fold filter if heavily
soiled and clean it (see chapter "Cleaning flat fold
filter").
Detergent pump noisy
 Fill up fresh water reservoir.
Strong foam generation in the container
 Use the correct detergent from KÄRCHER.
Appliance is not running
 Plug in the mains plug.

Technical specifications

Voltage
1~50-60 Hz
Output P
nom
Output P
max
Mains fuse (slow-blow)
Sound pressure level (EN
60704-2-1)
Weight (without accessories)
Subject to technical modifications!
– 8
EN
220 - 240 V
1200 W
1400 W
10 A
77 dB(A)
7,1 kg
13