Suction Process; Care And Maintenance - Kärcher IVC 60/24-2 Tact2 Lp Mode D'emploi

Table des Matières

Publicité

Rotating knob
Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the rotating knob.
Automatic filter cleaning
The appliance has an innovative dual filter cleaning sys-
tem that is particularly effective with fine dust. The flat
pleated filter is automatically cleaned every 7.5 seconds
through an air jet (pulsating sound).

Suction process

 Perform the suction process.
The vacuumed material only falls into the waste
hose when the device is switched off.
Check the filling level of the waste hose at regular
intervals, as the device does not shut off automati-
cally.
Illustration
 With light waste or in case of clogging: Pull out the
sheathed cable to open the flap on the outlet (only
possible when the device is switched off).
 Slightly pull down the waste hose, close it with 2 ca-
ble ties at a distance of 10 cm and cut it between
the cable ties.
 Dispose of the waste sack in accordance with the
legal requirements.
Note: With light waste the length of the waste sack can
be up to 2 m without it bursting.
Turn off the appliance
 Switch off the appliance at the rotating knob.
 Pull out the mains plug.
After each operation
Remove the disposal system
 Lock parking brakes.
Illustration
 Remove the tin tub.
Illustration
 Pull the locks of the placement mechanics up.
 Pull the push handle upward. The disposal system
is unlocked and lowered.
Illustration
 Pull the disposal system out by the handle.
Cleaning the device
 Vacuum and wipe the appliance inside and outside
with a damp cloth.
Appliance ON
Filter dedusting OFF
Appliance OFF
Appliance ON
Filter dedusting ON
Insert the disposal system
Illustration
 Reinsert the disposal system and lock it with the
push handle.
WARNING
Crush hazard. Never hold your hands be-
tween the disposal system and the inter-
mediate ring or put them near the lifting
mechanism while locking. Hold the dis-
posal system on the handle with one hand
and lock it by operating the push handle
with the other hand.
 Insert the tin tub.
Storing the Appliance
 Wrap the mains cord around the cable holder.
 Wind the suction hose around the sliding bow.
 Insert the floor nozzle and the suction pipe into their
respective holder.
 Place the appliance in a dry room and secure it
from unauthorized use.
CAUTION
Risk of injury and damage! Observe the weight of the
appliance when you transport it.
 Release the park brakes and push the appliance by
the push handle.
 Grab the appliance by the chassis, not by the slid-
ing bow to load it.
 When transporting in vehicles, secure the appli-
ance according to the guidelines from slipping and
tipping over.
CAUTION
Risk of injury and damage! Note the weight of the appli-
ance in case of storage.
This appliance must only be stored in interior rooms.

Care and maintenance

DANGER
First pull out the plug from the mains before carrying out
any tasks on the machine.
Exchanging the flat pleated filter
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into place.
Troubleshooting
DANGER
First pull out the plug from the mains before carrying out
any tasks on the machine.
Suction turbine does not run
 Check the receptacle and the fuse of the power
supply.
 Check the power cable and the power plug of the
device.
 Turn on the appliance.
EN
– 2
Transport
Storage
9

Publicité

Table des Matières
loading

Table des Matières