Tools Necessary For The Installation Of Up25 T - Up28 T -Up33 T - Up39 T - Up45 T Pumps; Pump Up25 T - Up28 T -Up33 T - Up39 T - Up45 T Installation - Ultraflex UP25 F Manuel D'installation Et D'entretien

ULTRAFLEX
6 Position the plastic hub-cap (10) with the water
discharge towards the bottom and fix it with the
3 self-tapping screws (11) supplied.
7 Position the steering wheel supplied
separately (12) on the pump shaft (13) by using
the suitable key (14). Insert the washer (15) and
tighten the self-locking nut (16) with a 19 mm open
end wrench and with a torque of 40 Nm (29,5 lb ft);
then grease the thread by using some anti-seize
®
grease MOLYKOTE
CAUTION
If the self-locking nut (16) is disassembled, it must
be replaced. (Contact our assistance service, see
page 6).
3.7 Tools necessary for the installation of pumps UP25 T - UP28 T - UP33 T - UP39 T - UP45 T
Open end
wrench
11/16"
3.8 Pump UP25 T - UP28 T - UP33 T - UP39 T - UP45 T installation
CAUTION
The tilt X52 mechanism is supplied separately.
1 Select a suitable place for the steering
station. Make sure that there is enough
manoeuvering space for the steering wheel and
for the steering pump and its pipes and fittings.
1000 or a similar one.
Screwdriver
Installation and maintenance manual
11
10

14
12
15
16
* The tools to assemble tilt X52 are listed
in the manual enclosed to tilt X52.
PUMP FOR HYDRAULIC SYSTEMS
13
min. 260 mm [10,24 in.]
page 21
- of 101