Tools Necessary For The Installation Of Pump Up20F; Pump Up20 F Installation - Ultraflex UP 20 F Manuel D'installation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ULTRAFLEX
3 INSTALLATION

3.1 Tools necessary for the installation of pump UP20F

Torque
MOLYKOTE® 1000
wrench

3.2Pump UP20 F installation

1
Select a suitable place for the steering station.
Make sure that there is enough manoeuvering space
for the steering wheel and for the steering pump and
its pipes and fittings.
WARNING
In order to fix the pump properly, the maximum
dashboard thickness must be 30 mm [1,18 in.].
Different thicknesses could compromise the driving
safety. Make sure that the breaking ring of the 3 self-
locking nuts supplied is engaged by the dowel thread.
2
Remove the plugs (1) from the pump (2) by using a
screwdriver.
3
Screw the nuts completely on the corresponding
90° unions (3), Fit and screw the unions manually as
indicated in the picture until they are inserted
completely. Turn them until they are positioned
correctly with respect to the pipes by unscrewing them
no more than one revolution, then tighten the nuts
with a 11/16" Allen wrench with a torque of 17,6 Nm
(13 lb ft) until the washer touches the nut.
WARNING
DO NOT USE teflon tape or adhesive tape.
DO NOT PUT any thread sealant like Loctite 542 or
similar products.
Drill
Open end
wrench
10 mm
System fitting
3
System fitting
PUMP FOR HYDRAULIC SYSTEMS
Installation and maintenance manual
Open end
Open end
wrench
wrench
19 mm
11/16"
max. dashboard
thickness 30 mm [1,18
in.]]
2
1
Connection for additional station
3
-
Screwdriver
min. 82 mm [3,22 in.]
1
Connection for
a d d i t i o n a l
station
page 11
of 71

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Up 20 t

Table des Matières