Ultraflex UP25 F Manuel D'installation Et D'entretien page 20

ULTRAFLEX
3 Put some fitting sealant type Loctite 542 or Loctite
545 on the thread. Fit and screw manually the conical
fittings (3) until they are completely inserted; then
tighten them with a 7/16" open end wrench with a torque
of 17.6 Nm (156 lb ft).
WARNING
Do not use teflon tape or adhesive tape. Pay attention
to the sealant positioning: if it is inserted into the
system, it could block it and make it unusable.
4 By using the proper template supplied with
this manual, make the holes required by the
installation in the suitable position on the
dashboard.
5 Position the pump (2) on the dashboard rear
side (5). Then position the gasket (6) as shown in
the picture and the flange (7) with the protective
projecting part towards the dashboard outside.
Fix the pump (2) with the 3 special screws (8)
with a torque of 25 Nm (18.5 lb ft).
CAUTION
Make the shaft pass through the flange equipped
with gasket by preventing the key seat from
damaging the gasket itself.
WARNING
Install the pump by positioning the filling hole
(9) towards the top (see the picture) for the right
pump operation and to allow filling and purging
the system completely (see par. 3.11).
page 20
of 101 -
PUMP FOR HYDRAULIC SYSTEMS
Installation and maintenance manual
System fitting
3
Connection for additional station
4
5
8
7
6
8
8
Connection for
additional station
System fitting
3
9
2