Tools Necessary For The Installation Of Pumps Up28 R -Up33 R - Up39 R - Up45 R; Pump Up28 R -Up33 R - Up39 R - Up45 R Installation - Ultraflex UP25 F Manuel D'installation Et D'entretien

ULTRAFLEX
3.3 Tools necessary forthe installation of pumps UP28 R - UP33 R - UP39 R - UP45 R
Torque
MOLYKOTE® 1000
wrench
3.4 Pump UP28 R - UP33 R - UP39 R - UP45 R installation
1 Select a suitable place for the steering station.
Make sure that there is enough manoeuvering space
for the steering wheel and for the steering pump and
its pipes and fittings.
WARNING
In order to fix the pump properly, the minimum dashboard
thickness must be 25.4 mm [1 in.] and the maximum
dashboad thickness must be 38.1 mm [1.5 in.]. Different
thicknesses could compromise the driving safety.
2 Remove the plugs (1) from the pump (2) by using a
screwdriver.
3 Screw the nuts completely on the corresponding
90° unions (3), Fit and screw the unions manually as
indicated in the picture until they are inserted
completely. Turn them until they are positioned
correctly with respect to the pipes by unscrewing them
no more than one revolution, then tighten the nuts
with a 11/16" Allen wrench with a torque of 17,6 Nm
(13 lb ft) until the washer touches the nut.
WARNING
DO NOT USE teflon tape or adhesive tape.
DO NOT PUT any thread sealant like Loctite 542 or
similar products.
Drill Screwdriver
System fitting
3
Connection for additional
station
PUMP FOR HYDRAULIC SYSTEMS
Installation and maintenance manual
Open end Open end
wrench wrench
13 mm 19 mm
min. dashboard thickness 25,4 mm [1 in.]
max. dashboard thickness 38,1 mm [1,5 in.]
min. 203 mm [7,48 in.]
2
1
3
-
Open end
wrench
11/16"
1
Connection for
a d d i t i o n a l
station
System fitting
page 17
of 101