Ultraflex UP25 F Manuel D'installation Et D'entretien page 23

ULTRAFLEX
5 Fix the pump to the bracket (3) supplied with
tilt X52 by using the 3 M8 screws (6) supplied
with tilt X52 according to the instructions enclosed
to tilt X52.
WARNING
Install the pump by positioning the filling hole
(7) towards the top (see the picture) for the right
pump operation and to allow filling and purging
the system completely (see par. 3.11).
6 Align and insert the tilt universal joint into
the pump shaft by loosening about 1-1.5 turns
the screws (8) on the universal joint itself always
according to the procedure described in the
installation manual supplied with tilt X52.
Retighten the screws (8) and fix the tilt.
NOTICE
The kit ULTRAFLEX supplied separately (see the corresponding instructions) can be used on pumps UP28
R-UP33 R-UP39 R - UP39-I R - UP45 R - UP45-I R and UP25 T-UP28 T-UP33 T-UP39 T - UP45 T to simplify the
hydraulic system filling and purging.
Installation and maintenance manual
3
6
8
PUMP FOR HYDRAULIC SYSTEMS
7
8
page 23
- of 101