Tools Necessary Forthe Installation Of Pumps Up39-I R - Up45-I R; Pumps Up39-I R - Up45-I R Installation - Ultraflex UP25 F Manuel D'installation Et D'entretien

ULTRAFLEX
7 Position the steering wheel supplied
separately (12) on the pump shaft (13) by using
the suitable key (14). Insert the washer (15) and
tighten the self-locking nut (16) with a 19 mm open
end wrench and with a torque of 40 Nm (29,5 lb ft);
then grease the thread by using some anti-seize
®
grease MOLYKOTE
CAUTION
If the self-locking nut (16) is disassembled, it must
be replaced. (Contact our assistance service, see
page 6).

3.5 Tools necessary forthe installation of pumps UP39-I R - UP45-I R

Loctite MOLYKOTE® 1000
542/545

3.6 Pumps UP39-I R - UP45-I R installation

1 Select a suitable place for the steering station.
Make sure that there is enough manoeuvering space
for the steering wheel and for the steering pump and
its pipes and fittings.
WARNING
In order to fix the pump properly, the minimum dashboard
thickness must be 25.4 mm [1 in.] and the maximum
dashboad thickness must be 38.1 mm [1.5 in.]. Different
thicknesses could compromise the driving safety.
2 Remove the plugs (1) from the pump (2) by using a
screwdriver.
1000 or a similar one.
Torque Drill
wrench
Installation and maintenance manual
14
12
15
16
Screwdriver Open end
wrench
13 mm
min. 200 mm [7,87 in.]*
*It depends on the pipe position
2
1
PUMP FOR HYDRAULIC SYSTEMS
13
Open end Open end
wrench wrench
19 mm 7/16"
min. dashboard thickness 25,4 mm [1 in.]
max. dashboard thickness 38,1 mm [1,5 in.]
1
page 19
- of 101