Abus Cms: Advanced Setting Options - Abus MODUVIS TVHS20 Serie Mode D'emploi

9.11 ABUS CMS: Advanced setting options

Below is a brief overview of the setting options via remote configuration with the ABUS CMS
software.
Each monitor and each door video module will appear in the network as a separate network
device, regardless of whether the device is connected via 2-wire or PoE.
Remote settings for TVHS20000(S), TVHS20010(S), video door module:
Device General information about firmware, serial
Information number
General Device name and device ID (not relevant
for door intercom system)
Time Settings for date/time, summer time and
NTP server
Maintenance Maintenance menu for firmware update,
set factory settings and restart device
User Menu is not used
RS485 Menu is not used
"Device type" must always be on "Outdoor
D
I
unit". Please do not change any numbers
Configuration
for the units "Period, Building, Unit, Floor"
as these values are not needed here.
Back doors are set up under "No.". 0 =
main doors, "1" – "9" = back doors.
Please consult the chapter "Setting up
back doors". (See Installation and
operating information)
Time Max talk time: Maximum conversation
Parameters duration for an accepted call. (90-120s)
Max Msg time: Recording time for
answering machine (30-60s)
3 additional PIN codes (6-digit) can be set
ermission
P
here to use in combination with
Password
TVHS20030.
ccess and Door. No.: Select between relay output 1
A
and 2.
Elevator
Open door time: Determines how long
Control
the relay should engage the door opener.
(1-255s)
"Door name" and "Card encrypt" not
used.
IO Settings for digital inputs (for emergency
Input/Output door opener) and the relay for door
opener.
142
"System" section
"Intercom" section