Activation Via Ip Network; Password Reset For Monitor/Video Door Module - Abus MODUVIS TVHS20 Serie Mode D'emploi

4.2.2 Activation via IP network

Install and start up the ABUS IP Installer (which is available for each respective product from the
ABUS website www.abus.com).
Each connected device should now appear in the selection list without the relevant IP address for
the target network, where appropriate.
Each device must first be enabled, i.e. a correspondingly secure password must be assigned for
the main user "admin". A secure password must meet the following minimum requirements:
- 8–16 characters
- Valid characters: numbers, lower-case letters, capital letters, special characters ( ! $ % &
/ ( ) = ? + - )
- You must use at least two different types of character
The IP settings for the camera can be changed using the IP installer.
The "browser" button is not available for door intercom system components as they do not have
their own web server.
Most programming for the components can be done on the door intercom system's monitor. For
more complex system setup, however, you will need to use the CMS software for programming
(connecting a component such as an IP device, open the menu item "remote configuration").
Activation in the IP network can also be done using the ABUS CMS software.
The ABUS CMS software may be necessary for certain other setup steps.

4.2.3 Password reset for monitor/video door module

To reset the password for monitors or video door modules, please contact our Technical Support.
100