Maintenance And Service; Filter Replacement - Hedson IRT 4-1 PCAUTO Mode D'emploi

Masquer les pouces Voir aussi pour IRT 4-1 PCAUTO:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
11.

Maintenance and service

Weekly
Check that all IR lamps light up during mobile dryer opera-
tion. Defect IR lamps can cause uneven heat distribution
over the surface.
Clean the dryer from dust, which can be a cause of fire, with
a damp cloth. Also, check that all cables are undamaged. A
damaged cable can be a danger to life!
Monthly
Check the gold reflectors. Damaged or extremely dirty reflec-
tors can over heat the reflector body and/or the cassette. In
case of doubt, please contact the customer service in order
to clarify if the gold coated reflector needs to be changed.
Yearly
Plan to change the air filter approx. once per year. You will
get a message in the software when it is time to change.
When starting up the dryer you will get an indication on
how much of the filter time that is used.
11.1

Filter replacement

Attention! The filters are disposable and should not be
reused.
1. Use a knife or screw driver to bend loose the two plastic
plugs at the cassette side plates.
2. Remove the used filter.
3. Insert the new filter so the IRT logo is visible from
the outside.
4. Place the long side of the filter opposite to the two plug
holes on the cassette according to picture.
5. Push in the filter until the two plastic "push-in-plugs" can
be reattached.
6. Reset the filter timer. Log into advanced settings mode
according to chpater 9.1 and 9.2. Move to parameter 45
and press yes for reset the filter timer.
713687 rev 9
y
z
11.2
IRT lamp replacement
Attention! Do not touch the gold coated
reflector or the new IR lamp with your fingers.
Only remove the protective paper on the IR lamp
after you have installed it.
1. Disconnect power supply.
2. Loosen the three top screws on the front plate of the
11
cassette.
2 kW
3. Disconnect the cable connector.
4. Loosen the four screws at the ends of the
reflector and remove the reflector from the
plate.
5. Remove the mesh and unscrew the lamp from
the two ends.
6. Install new lamps in the reverse order.
y
z
x
y
z
1 kW
2 kW
1 kW
x
y
z
12
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Irt 4-2 pcautoIrt 4-10 pcautoIrt 4-20 pcauto

Table des Matières