Setting The Grinding Fineness; Inserting The Filter; Setting The Coffee Strength - Beem SELECTION FRESH-AROMA-PERFECT Superior Mode D'emploi

29

Setting the Grinding Fineness

Turn the knob for adjusting the grinding fi neness (13) to the right or left so that the scale point
points to the position with the grinding fi neness you want (Picture A).
You can adjust the grinding fi neness to eight settings:
– all the way to the left: fi nest grinding level
– all the way to the right: coarsest grinding level
When you switch to another grinding strength, there will still be coffee powder with the
previous grinding strength in the grinder shaft.

Inserting the Filter

1. Press the release button for the fi lter compartment (4) (Picture B1).
2. Insert the fi lter insert (9) into the fi lter compartment (11).
3. Insert either the permanent fi lter (10) or a basket fi lter paper into the fi lter insert (Picture B2).
4. Close the fi lter compartment. It must engage audibly.
Basket fi lter papers are available via our website www.beem.de or from our customer service depart-
ment on request.
Setting the Number of Cups
Keep pressing the button
4, 6, 8, 10 or 12 cups).
The selected number of cups is saved until a new number of cups is set or the device has
been disconnected from the power supply for more than a minute.

Setting the Coffee Strength

Keep pressing the button
Weak coffee
Medium coffee
Strong coffee
The selected coffee strength is saved until a new coffee strength is set or the device has
been disconnected from the power supply for more than a minute.
Hotplate
The device has a hotplate which is switched on automatically after each brewing process. It
switches off again automatically after around 35 – 40 minutes. If you want to stop the keep-hot
function prematurely, press the button
chosen preparation type).
03201_DE-EN-FR-ES-IT_A5_V2.indb 29 03201_DE-EN-FR-ES-IT_A5_V2.indb 29
(19) until the display (15) shows the number of cups you want (2,
(20) until the coffee strength you want is shown on the display (15).
(14) or the button
EN
(16) (depending on the
31.01.2019 11:57:02 31.01.2019 11:57:02