Electrical Panel In Remote Location; Final Assembly - Zephyr DLI-E30ASX Mode D'emploi

Electrical Panel in Remote Location

1
I
Remove electrical panel (I) from downdraft (B). Electrical panel connector
cable legth is 2 feet. Optional 5 foot cable extension available.
Note: Option for most installations. Required for DBI-600A blower installa-
tions when discharge is down.
2
Install electrical panel
in remote location.
Preparing the Downdraft

Final Assembly

3 3
B
E
Attach previously removed lower support legs (E) to downdraft (B) using one
nut for each leg.
4
Slide upper support brackets (A,J) into side channels of downdraft (B).
5
If using DBI-600A blower, attach blower support legs with supplied
screws.
13
B
E
A
B
DBI-600A Blower Only
J