Husqvarna CA230 Manuel D'utilisation page 249

Cutting attachment guard
This guard is intended to prevent loose objects from being
thrown towards the operator. The guard also protects the
operator from accidental contact with the cutting
attachment.
• Ensure that the guard is undamaged and is not
cracked.
• Replace the guard if it has been exposed to impact or
is cracked.
Cutting equipment
The tines are designed and machined to withstand the
loads resulting from cultivating.
The two basic rules:
1 Only use cutting attachments with the guards we
recommend!
SAFETY INSTRUCTIONS
2 Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be
replaced.
WARNING! Always stop the engine
!
before you work on any part of the
accessory. It can continue to move even
after the throttle is released. Ensure the
accessory has stopped completely and
disconnect the HT leads from the spark
plug before you start to work on it.
WARNING! Never use a machine with
!
faulty safety equipment. The machine's
safety equipment must be checked and
maintained as described in this section.
If your machine fails any of these checks
contact your service agent to get it
repaired.
–
English 249