Philips sonicare AirFloss Pro Mode D'emploi page 10

ENGLISH
10
- Triple burst: 3 LEDs
Note: The AirFloss Pro remembers what mode was
selected last and it is ready for the next use. If your
AirFloss Pro becomes fully drained of power, it will go
back to the triple burst default mode once it has been
recharged.
2 Place the nozzle tip between two teeth at
your gum line. Slightly close your lips over the
nozzle when it is in place, to avoid splashing.
3 Press the activation button to deliver 1-3 bursts
(depending on the selected mode) of air
and micro-droplets of mouthwash or water
between the teeth.
4 Slide the nozzle tip along the gum line until you
feel it settle between the next two teeth.
5 Continue this procedure for all spaces between
your teeth, including behind your back teeth.
Note: Refill the reservoir as needed.
Auto-burst function
Hold the activation button to deliver bursts
continuously, approximately one second between set
of bursts.
1 To turn off AirFloss Pro, press and hold the
power/mode button for one second.