General Information - BIO UV MP030 Serie Notice De Montage Et D'entretien

GENERAL INFORMATION:

Some of them aren't available on your device according to your reactor type.
R means that the reactor is switched on and operating.
means that the water is flowing and that the flow is adequate in relation to the
F
setting that you made on the flowmeter.
C means that the automatic cleaning function is activated.
Note: for the reactors which don't have a flowmeter, the letter "F" stays always on the display.
● The screen is backlit: Just pressing on a key switches the back lighting on for one minute.
● Activation/deactivation of automatic cleaning: Pressing simultaneously on buttons A and B activates or
deactivates the automatic cleaning.
● Caution: if the cleaning is deactivated when the hydraulic cylinder is operating, the cleaning carriage may stop
in the middle of the reactor and block some of the UV rays.
ALERT MESSAGES:
The screen flashes when there is an alert message.
The alert messages are always shown on the secondary display and are independent of what is displayed on the
main display unit.
Display
This message appears when the
temperature of the cabinet exceeds 60°C.
The reactor is stopped automatically.
This message appears when the
temperature of the reactor exceeds
44.5°C.
The lamps are stopped automatically.
This message appears when one or
several lamps are faulty.
The numbers show which of the lamps
are faulty.
This message appears when the
hydraulic cylinder on the automatic
cleaning is blocked.
This message appears when the intensity
of the UVC radiation falls below the
pre-alarm threshold.
N.B.: when the lamps have been operating for a certain number of hours, this message appears naturally (normal wear of the lamps)
This message appears when intensity of
the UVC radiation falls below the main-
alarm threshold.
This message appears when the lamps have been stopped (brought about by a safety
device). The lamps will not be relit until after a time delay of 30 minutes. This time delay is
to protect the lamps.
MP 030 EL NM GB
Marque, Modèles et Brevets déposés - Produits exclusifs
This operating manual describes all possible options,
Definition of the 3 letters on the first display
Meaning of the alert
These 4 alert messages can be cleared by pressing on the key "OK".
It is preferable to carry out a maintenance operation before clearing the fault.
These 3 messages cannot be cleared unless the problem has been resolved.
Solutions
Check that the cabinet vents are not blocked.
Check that the fans are working properly.
Check that enough water is flowing through the
installation.
If there is a flowmeter, check that is correctly
calibrated.
Diagnose the cause of the breakdown.
Diagnose the cause of the breakdown.
Check that the quartz sleeves are clean.
Check that the UV sensor is clean.
Check that the quartz sleeves are clean.
Check that the UV sensor is clean.
Chang the UV lamps.
Copyright BIO-UV - 29/01/2009
Page 15