GEO plast GEObox Speed 12 Manuel page 19

5.2. FILLING INSTRUCTION
1) Connect filling and suction pipes
2) Turn suction on full power
3) Start supply of pellets slowly
4) Fix screw cap after finishing the filling process
ATTENTION: There should always be more air sucked off than blown into, as the movement of the air inside the fabric circulates from inside out.
Consequently an almost dust-free filling is possible.
A small tip for an optimal filling of the pelletbox: Switch the hoses after filling (put the pellet feed hose on the acces for pellet return air hose and
vice versa. This way the dumping angle can be minimized. (up to 300 kg pellets can be brought in additionally!)
THE PELLETBOX MUST ONLY BE FILLED WITH A MAXIMUM PRESSURE OF 0,2 BAR!
TO AVOID ELECTROSTATIC CHARING THE PELLETBOX
MUST BE CONNECTED TO THE HOUSE EARTHING!
E
N
G
L
I
S
H
19