CERTIFIED 060-1310-2 Guide D'utilisation page 28

See Fig. 33.
2. Secure scraper blade assembly to housing with
original hardware.
3. Install spring hooks to frame and around scraper
blade. Make sure blade has tension.
Storing the snowblower for short periods
The snowblower can be stored for short periods of time (less than 15 days) without performing any
storage maintenance. Before placing the snowblower into storage always carry out the following:
1. Allow the engine to fully cool.
2. Clean all debris from the snowblower deck.
3. Store the snowblower on flat and level surface.
4. Store in a safe place which is not accessible by children or people who are not familiar with
operation.
Storing the snowblower for extended periods
If the snowblower is to be place into storage for more than 15 days, storage maintenance must be
performed on the snowblower. If the following steps are not carried out, when you next operate the
snowblower it may not start correctly and may need to be serviced.
CAUTION! Do not empty the gas tank in enclosed areas, near fire or when smoking. Gas
fumes can cause explosions and fire.
1. Empty the gas tank with a gas 'gas extraction pump' was used on page 23 if available.
2. Start the engine and let it run until any remaining gas has been used up.
3. Change the oil at the end of every season. To do so, remove the used engine oil from a
warm engine and refill with fresh oil.
4. Clean the cooling fins of the cylinder and the housing.
5. Be sure to clean the entire machine to protect the paint.
6. Store the machine in a well-ventilated place.
27
Fig. 33