CERTIFIED 060-1310-2 Guide D'utilisation page 21

20
model no. 060-1310-2 I contact us: 1-844-428-7277
Note: If the recoil starter does not operate properly, it may be frozen. Thaw out the starter
before attempting to start the machine.
NOTE: If the engine fails to start after three pulls, repeat the process.
1. Pull the recoil start handle out
approximately 4" to 6"(10 to 15 cm) until
you feel a resistance and then start the
engine with a sharp pull (Fig. 16)
2. Once the engine is running, put the starter
rope into the rope guide (see Fig. 16).
While the engine is running, move the choke
lever gradually to the "RUN" position;
CAUTION! If you leave the machine
plugged into a power source, someone
can inadvertently start the machine
and injure people or damage property
Unplug the power cord whenever you
are not starting the machine
Stop the engine
To stop the engine, pull the ignition key outward.
Engaging the Auger Paddle
To engage the auger paddle, hold the auger
control lever against the handle (Fig. 17).
Disengaging the Auger Paddle
To disengage the auger paddle, release the
control bar (Fig. 18).
Adjusting the Discharge Chute and Chute
Fig. 16
Fig. 17
Fig. 18