CERTIFIED 060-1310-2 Guide D'utilisation page 15

14
model no. 060-1310-2 I contact us: 1-844-428-7277
Installing the Discharge Chute
Install the discharge chute assembly as shown
in Fig. 3.
Make sure the discharge chute rotation
handle and discharge chute is in the correct
position, tighten 3 screws with the spanner
cross-head end.
Adjusting the Control Cable
Checking the Control Cable
Before each use, check the control cable and
adjust it if necessary.
CAUTION: You must check and may need to adjust the control cable before you
operate the machine for the first time.
Adjusting the Control Cable Fig. 4 to 5
1. Stop engine and wait for all moving parts to
stop and for hot parts to cool.
2. Move plastic sleeve up to auger control
lever.
3. Remove cable end from adjustment bracket.
4. Insert Z-hook into highest adjustment
bracket hole reachable.
5. Wrap cable end around adjustment bracket.
IMPORTANT: When auger control lever is
disengaged, there should be slight slack in
the cable and no tension.
6. Start engine and engage auger control lever
to ensure proper operation.
7. Release auger control lever and ensure
paddle rotation stops.
IMPORTANT: Cable tension should not be
excessive.
8. Reposition sleeve over adjustment bracket.
1
2
3
1. Plastic Sleeve
2. Z-hook
3. Adjustment Bracket
Fig.3
Fig.4
Fig.5