Hilti DX 9-ENP Mode D'emploi page 12

Thermal safety rules
▶ Do not exceed the maximum fastener driving rate recommended in the section headed "Technical data".
▶ If the fastening tool overheats or if the cartridge strip deforms or melts, remove the cartridge strip and
allow the fastening tool to cool down.
▶ Do not dismantle the fastening tool while it is hot. Allow the fastening tool to cool down.
Risk of explosion with cartridges
▶ Use only cartridges that are suitable and approved for use with the fastening tool.
▶ Remove the cartridge strip when you are going to take a break and when you have finished the job, and
before you transport the fastening tool.
▶ Do not use force to remove fasteners and/or cartridges from the magazine strip or the fastening tool.
▶ Store unused cartridges in accordance with the storage specifications for cartridges for powder-actuated
fastening tools (e.g. dry, temperature between 5 °C and 25 °C) in a secured storage facility.
▶ Do not leave unused or partly used cartridge strips lying around. Collect the used cartridge strips and
store the cartridge strips at a suitable location.
▶ Follow all instructions relating to safety, handling and storage in the safety data sheet of the cartridges.
3 Description
3.1 Overview of the product
3.2 Intended use
The product described is a fastening tool designed to drive special fasteners for fastening trapezoidal profile
metal sheets to steel beams.
3.3 Possible misuse
The fastening tool may not be operated in atmospheres or environments where there is a risk of fire or
explosion.
The fastening tool may not be used with cartridges and fasteners other than those approved for use with this
fastening tool.
4 English
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
£
|
Display
Bluetooth button
Reset button
Grip
Cartridge loading channel
Power regulation wheel
Rotating sleeve
Nosepiece (interchangeable)
Base plate
Magazine release button
Carrying handle
Magazine
Trigger button
Cartridge exit opening
Catch
2194400
*2194400*