Chef Connect - GE UVC7300 Manuel Du Propriétaire Et Instructions D'installation

Chef Connect

Chef Connect Operation Bluetooth
To pair with another device:
To start the pairing process on the hood, press and hold
the Chef Connect button for 3 seconds. The backlight
for the Low-Med-High-Light-Chef Connect buttons will
flash in that sequence until the hood is paired with the
range or other device. If the pairing is successful, all five
backlights (Low, Med, High, Light, Chef Connect) will
flash simultaneously three times and then turn off and
the Chef Connect indicator light will turn on.
It will time out after 2 minutes if the pairing is not
completed, after which the pairing sequence will need to
be restarted.
To cancel pairing:
To cancel the pairing, hold the Chef Connect button
down for 3 seconds and then turn off the hood.
6
® Connection
Default Sync Settings:
The factory default setting for the light will be the
brightest.
The factory default setting for the fan sync will be OFF.
The user can change the Default Sync Settings by
pressing and holding the Low button for 3 seconds. This
will enter the Default Settings Mode. Once in this mode,
the backlights for all buttons (Low, Med, High, Light,
Chef Connect) will blink On/Off indefinitely and the fan
and light will switch to the current Default Sync Setting,
so the user knows what the current default value is.
At this time, set the light and fan to the desired default
levels. Once the user is satisfied with the selection, press
and hold the Off button for 3 seconds. This will exit this
mode. At that time the backlights will stop blinking and
the state of the fan and light will change back to their
prior state before entering the Default Settings Mode.
49-2000893 Rev. 0